Mongoose parts...
Where possible, I've chosen to use materials that you should be able to find at any well stocked kite shop. This page is a list of the specifications for each part in your kite.
These charts only reflect the latest specifications for each model. Check carefully that the part I list is the same for your kite. If you don't see exactly what you need, or have any questions, send me a note at ken@bluemoonkites.com
The full range of finished replacement parts, as well as unfinished tubes and fittings, is available.
| Mantis Nitro Parts | |
|---|---|
| Description | Specifications |
| Spine | SkyShark P300 @ 31.5" |
| Spine Extension | .240 w/fittings |
| Upper Leading Edge | SkyShark Nitro @ 31.0" 2 |
| Lower Leading Edge | SkyShark Nitro @ 31.0" 2 |
| Lower Spreader | SkyShark Nitro Black Diamond @ 32.5" 3 |
| Upper Spreader | .220 pultruded @ 21.5" |
| Custom leading edge fittings | Custom APA Ca |
| safety nocks, .254 | .254 safety nocks for BD Nitro |
| T Ferrule | .285 solid x 4.0" |
| Stand-offs inner | 3mm carbon rod @ 10.25" 1 |
| Stand-offs outer | 3mm carbon rod @ 9.625" 1 |
1 posted standoff dimensions are the length of the rod only, not the finished part.
2 Nitro tubes can be cut at either end. I always cut them at the big end to customize the flex profile to the kite.
3 "PT" series tapered tubes should always be cut at the smaller end.
